Kitfox™ SERVICE LETTER # 5

SUBJECT:    FAB-li & FAB 13 BUSHINGS, ELEVATOR CONTROL TUBE

TO:    Kitfox™ SERIAL NUMBERS 56-112

FROM:    DENNEY AEROCRAFT COMPANY

FAB-11 & FAB-13 BUSHINGS: If the aft elevator tube has not been assembled, follow the instructions in this letter. Refer to page F-6 step 8. If the length of the smaller diameter of either the FAB-il or the FAB-13 is less than 9/16” the first sentence of the NOTE under step 8 should be amended as follows:

Drill 2 #30 holes (180 degrees apart) not less than 3/16” from the end and drill 2 #30 holes not more than 3/8” from the end at 90 degrees from the first set. The above dimensions are for the smaller diameter of FAB-il & FAB-13 only. Use the regular dimensions for the large diameter end of the parts.